Arduino library that controls the (7-segment 1-digit) display with 'Shift Register'
Open up the Arduino with a new blank project, then after hooking up everything.. copy/paste the following:
#include <DigitShifter.h>
// built by: AbdulMuaz Aqeel (Senior Software Engineer)
// For More Please Visit:
// https://github.com/devmuaz
// https://www.facebook.com/devmuaz
//
//
// DigitShifter is an Arduino C library that can easily control
// the 7-segment 1-digit displays for both (Anode and Cathode)
//
//
// Shift Register (74HC595) PinOut
//
// SHIFT __ SHIFT SHIFT _____
// VCC Q 0 DATA OE LATCH CLK RESET Q 7'
// | | | | | | | |
// ---------------------------------------------------------
// | |
// |__ |
// |__| 74HC595 |
// | |
// | |
// ---------------------------------------------------------
// | | | | | | | |
// Q 1 Q 2 Q 3 Q 4 Q 5 Q 6 Q 7 GND
//
// Hooking Up Table with both
// IC pinOut | display pinIn
// -------------------------------
// Q 0 | A
// Q 1 | B
// Q 2 | C
// Q 3 | D
// Q 4 | E
// Q 5 | F
// Q 6 | G
// Q 7 | DOT (OPTIONAL)
//
// By Default >
// DigitShifter ds(SHIFT_DATA = 2, SHIFT_CLK = 3, SHIFT_LATCH = 4);
//
// 1: connect pin 'SHIFT LATCH' to pin 4 in Arduino
// 2: connect pin 'SHIFT CLK' to pin 3 in Arduino
// 3: connect pin 'SHIFT DATA' to pin 2 in Arduino
// Then in code just make an instance of DigitShifter (DigitShifter ds)
//
// OR
//
// connect these pins in anywhere but in sequence
// DigitShifter ds(SHIFT_DATA, SHIFT_CLK, SHIFT_LATCH);
DigitShifter ds(
2, // Pin 2 in Arduino connected to SHIFT DATA in IC
3, // Pin 3 in Arduino connected to SHIFT CLK in IC
4 // Pin 4 in Arduino connected to SHIFT LATCH in IC
);
void setup() {
// Then call member function displayDigit(int num, TYPE type)
// Set the number you want to display (0 - 9)
// Set display type (CATHODE or ANODE)
ds.displayDigit(1, ANODE);
}
void loop() {
for(int i = 0; i < 10; i++){
ds.displayDigit(i, ANODE);
delay(1000);
}
for(int i = 9; i >= 0; i--){
ds.displayDigit(i, ANODE);
delay(1000);
}
}If you like it, star it ❤️